← 返回首页
Pinpoint regressions with Git
Page history
Edit this page
How do I edit this website?

ImageJ Docs

Pinpoint regressions with Git

How to bisect with Git

How to find which commit introduced a regression

So you found a regression? I.e. you know that the version worked perfectly that you had yesterday of, say, the ImageJ Ops library, but today it crashes?

Git-bisect to the rescue!

git bisect start git bisect bad HEAD git bisect good HEAD@{yesterday}

This will start the bisection process, i.e. it will try to find a revision that is as much “in the middle” between the bad commit(s) and the good commit(s) (you will mark more and more commits as good or bad in the process, and by inference, the ancestors of good commits will be considered good, and the offspring of bad commits will be considered bad, too), and let you test that.

In our case, let’s just run the unit tests:

mvn clean test

If the test is undecided (e.g.: it does not compile, so you do not know if the unit test in question passes), mark it with

git bisect skip

otherwise, mark it as “bad” or “good”.

Sooner or later (usually rather sooner), Git will tell you which commit is the culprit. You can look at the corresponding patch with

git show <commit name>

where the commit name is that 40-digit hex string Git told you was the first bad commit. Usually you end the bisection process then and there:

git bisect reset

This will bring you back to the revision and branch you were on before starting the bisection.

How to forward port a fix

If there is an obvious flaw in the patch, just try to patch it. You have to move to the first bad revision first:

git checkout <commit name>

(This will warn you that you are not on any branch, but that is okay.) Then just apply the fix you have in mind, and commit (after making sure that it worked, of course ;-). Now, tag it with a temporary label:

git tag my-fix

and go back to the branch you came from:

git checkout main

If you are unsure which branch you came from, look at the reflog first.

Now you can cherry-pick (or forward-port) your patch:

git cherry-pick my-fix

If there are conflicts, resolve them and commit (“git commit fiji.cxx”).

After that, you can get rid of the now-obsolete tag:

git tag -d my-fix

Note: instead of using a temporary tag, you can use the reflog of the HEAD ref (git cherry-pick HEAD@{1}), but if you are not familiar with the concept, tags are probably easier to handle.

See also

ImageJ Docs